Measuring systems for liquids other than water, gas meters and gas volume conversion devices are now covered by the Measuring Instruments Directive.
> More information
If your measuring instrument is in the process of being developed or you wish to assess/review the conformity of one of your instrument's functions, LNE can perform a pre-diagnosis of conformity covering all or part of the statutory requirements.
Download application form
(pdf - 25 kB)
Type examination covers validation of the design of a measuring instrument on the basis of information supplied in an application file and - if required - examinations and tests performed on one or more specimens of the instrument type. Following type examination, LNE will issue a certificate stating that the instrument meets the requirements for its category. If applicable, the certificate will specify particular conditions for verification or use of the instrument.
To apply for type examination, you need to send LNE:
Note: If your application is for an instrument with integrated software, please complete the technical file as indicated in the software file guidelines - [software guidelines] (pdf - 97 kB)
| Technical file guidelines | |
|---|---|
| Instruments for measuring the quantity of heat supplied to premises | guidelines |
| Cold and hot water meters MID | guidelines |
| Active electrical energy meters MID | guidelines |
| Thermal energy meters MID | guidelines |
| Gas meters and volume conversion devices intended for residential commercial and ligt industrial use MID | guidelines |
| Gas meters intended to be used in heavy industrial use | guidelines |
| Level indicators | guidelines |
| Systems for continuous and dynamic measurement of quantities of liquids other than water MID | guidelines |
| Gas volume vacuum gauges | contact us |
If you wish to transfer or extend a type examination certificate, please fill in the form (french version only - pdf)
CE marking on a new or repaired instrument indicates that it meets the requirements covering its category. Directives 90/384/EEC (NAWI) and 2004/22/EC (MID) specify that CE marking may be affixed by a manufacturer whose quality system has been approved by a Notified Body. LNE is notified to perform quality system approval (for all modules requiring quality assurance).
French regulations (Décret of 3 May 2001) make similar provisions for companies that manufacture, repair or install measuring instruments.
Read our [guidelines] on the approval procedure (pdf - 415 kB) and then complete and send us the [application form] (pdf - 85 kB) and the [application file] (pdf - 73 kB)
LNE ISO 9001 certification Companies applying for quality system approval may also apply for ISO 9001 certification of their quality management system. This certification is extremely useful both for SMEs and for large companies whose certification needs concern different parties (buyers, local authorities, subcontractors, etc.). LNE provides a one-stop service optimizing both the time and the cost of the certification process. > LNE ISO 9001 certification (french pdf - 860 kB) |
 |
LNE performs EC unit verification of measuring systems for liquids other than water
To apply for EC unit verification, download the file guidelines (pdf - XX kB)
To apply for design approval, download the file guidelines for the type of measuring container concerned:
| Technical file guidelines | |
|---|---|
| Oil tanks | guidelines |
| Tanks | guidelines |
| Wine vats | guidelines |
LNE is authorized to issue OIML certificates of conformity for over 20 categories of measuring instruments. It is also a signatory of a Mutual Acceptance Agreement covering load cells (OIML recommendation R60) and non-automatic weighing instruments (OIML recommendation R76).
The OIML international recommendations for which LNE may issue OIML certificates are listed on the OIML website.
Send LNE a full description of your instrument, by completing our application form (pdf - 29 kB)
For any new application for certification of measuring instruments, contact our customer service
